||3P 600V 50A
||3P 600V 80A
||3P 600V 120A
||3P 600V 150A
||4P 600V 50A
||4P 600V 80A
||4P 600V 120A
||4P 600V 150A
||6P 600V 50A
||6P 600V 80A
|Cross Sectional Dimension & Properties
- Rating : 3P, 4P, 6P; 600V; 50A ~ 150A.
- Conductor Material : OFC 99.99% fine copper.
- Insulator : Rigid PVC (Heat Resistance 75°C) Orange (Hazard Color), Munsell 2.5YR6/13.
- Installation Method : Tension type.
- Available Length : Continuous up to 1000m
- Max. Radius Bending : 800mm.
- Max. Conducting Speed : 300 m/min.
- Suitable for vertical installations * Indoor use only.
POWERFLUX safety power rails are electrical conductors of various
profiles that are used to provide electrical potential to moving systems
along a path of travel which have 3-6 poles power terminals. POWERFLUX
safety power rails are available or a current load from 50A up to 150A
mobile electrification technology for moving transportation vehicles and
equipment. Common application include : manufacturing robots, material
handling systems, hoist and cranes, automated storage facilities and
retrieval systems. POWERFLUX safety power rails are available in variety
of configuration depending on applications requirements. Enclosed
conductor systems typically enclosed conductors in a protective conduit
meeting safety standard. POWER CALCULATION (1) Determine the motor load
current by calculation based on the nameplate, catalogue, indoor wiring
regulations, and other pertinent regulations. For a general estimation,
assume 4A per 1Kw at 200V (2) If the demand factor, power factor and
other relevant values are known, use them to correct the calculation for
the load current. Also, try to select the most cost-effective setup,
taking such points as additional power installation into consideration.
(3) for an overhead traveling crane, you may use the following equation
for calculation :
EFFECT OF VOLTAGE DROPS
When the installed wiring is very long, voltage drops affect the motor
and other loads positioned far from the power supply. If the voltage
drop is too extreme (according to calculation of rop at the farthest
point from the power supply when the total load current is applied), the
rated current on the wiring should be raised by one step, or the power
supply points should be changed or increased in number. The voltage drop
in between the distribution board and the power supply points should
also be taken into account. VOLTAGE DROP CALCULATION EQUATION (three
phase, three wire) :
E = √3 * I * Z * L
Where “I” is total rated load current (A), “Z” is impedance (Ω/m), and “L” is line length (m).
** For example 50A rated current will be installed for 90m, the drop voltage will be 5V as shown on the chart.
** Generally for more than 100m installation, use middle power feed to minimize the drop voltage effect.